Rocky-mountain-radar Мото-Raptor User Manual

1 MOTO-RAPTOR Advanced Micro Technology Design Remote Radar and Laser Detector Owner’s Manual Rocky Mountain Radar

10 VOLUME DOWN BUTTON Press Volume down button to decrease it from level 5 to level 1. Volume levels 1 and 5 give one long beep and leve

11 HEAD SET LOW BATTERY ALARM The Head Set will give a beep alert with the LED blinking 5 times every 20 minutes if the Head Set is r

12 FREQUENTLY ASKED QUESTIONS Is the Radar Detector water proof? The Radar Detector is weather proof. The Radar Detector was designed to be resi

13 Will the Head Set bend with the air if so what can be done to prevent it? The Head Set should not move with the air as long as it was installe

14 LIMITED WARRANTY The manufacturer warrants your Moto-Raptor against all defects in materials and workmanship for a period of one (1) yea

15 SPECIFICATIONS RADAR - Receiver Type: Dual conversion superheterodyne - Antenna Type: Linear polarized, self-contained Antenna - Device Type:

16 ACCESSORIES: __________________________ Accessories are available as follows: Head Set……………………………………………………..……… $150.00 Radar Detector……………………

17 Serial Number: ____________________________________ Date of purchase: _________________________________ Purchased From: __________________________

18 MEMO

19

2

20 Rocky Mountain radar 6469 Doniphan Drive El Paso, Texas 79932 (915)587-0307 Phone (915)587-6408 Fax Follow us on Face book w

3 TABLE OF CONTENTS Introduction--------------------------------------------------------------- 4 Safety Warning ------------------------------------

4 INTRODUCTION Dear Owner, Congratulations on your purchase of the world’s most sophisticated motorcycle radar and laser detector. The

5 SAFETY WARNING While using the Moto-Raptor Radar and Laser Detector, it is the sole responsibility of the operator to properly install the

6 COMPONENTS Your Moto-Raptor package consists of the following components. (1) Radar Detector (1) Head Set (1) Bracket for Radar Detector (2) Screw

7 CONNECTING TO POWER SUPPLY Connect the Radar Detector power cable to any power source that has 12V and is powered with the ignition. Exampl

8 WIRELESS HEAD SET Before installing the Head Set make sure you leave enough space to be able to position the LED in view. Mount the Head Set on t

9 LED DISPLAY OPERATION The LED of the Head Set displays all of the different radar and laser alerts. - On Standby: LED is OFF - K band, Ka band